You can bend its legs to post as I did in the above photos. Shaun the Sheep Pom Pom Sheep is completed. ![]() Leave it overnight to let the glue dries completely. You can see clearly the position of where you can attach the legs. You can put some more glue surrounding each leg, but not too much, just enough for tacking the surrounding yarn. Do adjustment accordingly if they are not level. Check and see if all 4 legs touch the tabletop. Test the level of the legs by letting it stand-up while holding it. Continue with your drink and come back another hour later.Īpply some fabric glue to the knot-less end of the leg. If you think that it is not secure enough for you to work on it, leave it to dry for a little longer.Īttach the head to the body. Have a drink and come back in an hour’s time. It took about 1 hour to dry to the extent that you can work on it again without fearing that it would fall apart. The eyes shown here are slightly bigger which I replaced it later with the 6mm eyes that suit Shaun’s face better. Use a 1 ⅜" pom pom maker to make 1 beige pom pom and trim it with the face/tail template for the tail, you might want to trim it a little slimmer so that it won’t look exactly like the face.Īttach the eyes, ears and top hair. You can add a key-chain if you plan to make it as a key chain. Use a 1¾" pom pom maker to make 1 beige pom pom and trim it with the body template. Use a 1⅜" pom-pom maker to make another beige pom-pom but this time wind a little lesser than usual cause you want to trim it to a small pom pom for the top hair with 25mm diameter if you look from the top and 13mm height with a flat bottom and a little dome on the top. Use a 1⅜" pom-pom maker to make 1 black pom-pom and trim it with the face/tail template for the face. A pair of ears cut out from black felt, ¾" in length, 5/16" on the widest part and ⅛" on the slimmest part. It should look like this after the glue is dried. Push the wire until it goes into the knot a little bit. Slowly insert the floral wire into the cord. Cut floral wire by using the wire cutter to a length of 1½". ![]() Cut the black cotton cord to about 3" length, tie a knot at the end of the cord, leaving about ¼" at the end. Let's begin to make pom pom sheep by preparing the parts by following these instructions. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |